Home › RF Design Tools › Components › Pi / T Attenuator
RF DESIGN TOOL · ATTENUATOR

Pi and T Resistive Attenuator Calculator

A resistive attenuator reduces the signal by a set number of dB while keeping both ports matched to the system impedance (e.g. 50 Ω). Enter the attenuation and impedance to get the resistor values for both Pi and T networks – useful for level setting, improving match and protecting test equipment.

Pi and T at onceMatched to Zo on both portsCommon dB tableResistance in Ω

① Input Parameters

Both networks give the same attenuation and match. Pick the one whose resistor values are easier to realize with standard parts.

② Results

PartPositionResistance
Pi network
R1shuntΩ
R2shuntΩ
R3seriesΩ
T network
R1seriesΩ
R2seriesΩ
R3shuntΩ

Pick the nearest E96 (1 %) standard values; use thin-film chip resistors at high frequency.

Pi Attenuator

R1R3R2ZoZo

T Attenuator

R1R2R3ZoZo

Common Values (current Zo)

dBπ R1=R2π R3T R1=R2T R3

Values in Ω, rounded to one decimal.

How to Use

  1. Enter the required attenuation ATT in dB (must be greater than 0).
  2. Enter the system impedance Zo (50 Ω for most RF, 75 Ω for video/CATV).
  3. Click Calculate to get R1, R2 and R3 for both the Pi and T networks; the diagrams show each value.
  4. Choose the nearest standard resistors and make sure their power rating covers the input power.

Theory & Formulas

A matched attenuator presents Zo at both ports; the resistor values depend only on the attenuation:

K = 10ATT/20 (voltage ratio)
Pi: R1 = R2 = Zo·(K + 1)/(K − 1) R3 = Zo·(K² − 1)/(2K)
T: R1 = R2 = Zo·(K − 1)/(K + 1) R3 = 2Zo·K/(K² − 1)

Pi or T?

Electrically they are equivalent. At low attenuation the Pi network has large shunt resistors and a small series resistor, while the T network has small series resistors and a large shunt resistor; choose whichever you can build most accurately from standard values. At high frequency resistor parasitics shift the real attenuation, so split large values into two cascaded stages.

Design Tips

FAQ

How is this different from a single series resistor?
A single resistor changes the impedance and causes reflections; a Pi or T pad attenuates while keeping both ports at Zo.
Can I enter fractional dB values?
Yes, e.g. 0.5 dB or 1.5 dB. The attenuation must be greater than 0, otherwise it is reset to 3 dB.
Does it work for 75 Ω systems?
Yes – set Zo to 75 and all resistor values scale accordingly.

Related Design Tools

Designing an RF product? WENSHING supplies RF transceiver modules, LoRa modules, SMD ceramic antennas, directional antennas and UHF RFID readers, and offers custom RF circuit design support.

Contact an Engineer