WS-RFIDBY-PLUS2: English translation of the project source UI. Read-only preview, not connected to a device. Values are blank or source defaults. Menu options do not establish implementation or compatibility; confirm the supplied firmware.
Settings locked (over 1 hour). An administrator can unlock them.

Dashboard

PWR
ETH
WiFi
BLE
RFID
RS485
CAN
TRIG
RJ45
1234
RS-485 A B V+ GND
CAN CANL CANH V+ GND
Current: RS-485
DC 12V

WS-RFIDBY-PLUS2

System information

Firmware version-- MAC-- Free memory-- Uptime-- ADC current-- mV Chip temperature-- °C Network time-- NTP synchronizing

Interface status

RJ45_._._._ WiFi_._._._ AP_._._._ RFID-- Communication interfaces-- External trigger--

RFID settings

Source UI note: hardware range 900–930 MHz; ETSI 865–868 MHz and CHN1 840–845 MHz are not listed. Confirm the delivered hardware.

Maximum 300 ms (0.3 s); uncheck to mute

Tag list

EPCCountLast seen

Network settings

Wireless communication settings

AP and STA can be enabled separately (AP hotspot / STA connection to existing WiFi). Saving causes the device torestart automatically to apply settings。

Wired network

Connect Ethernet to obtain an IP address using DHCP. The current IP appears in the RJ45 hardware status field above.

Tag forwarding server (host IP)

After reading a tag, the device forwards its data to the configured server IP and port.
Forwarding route: determined by wireless mode
0 = send immediately after reading; >0 = batch every N seconds

Live forwarding statistics Updates every 2 seconds on the device

Status-- Queue-- Sent-- Dropped-- Errors-- Last error code--

Communication interface settings

Interface selection (shared 4-pin PCB terminal; select one interface)

CAN bus settings (TCAN3413, pin21/22)

Raw mode: field unused
TX count-- RX count-- Errors-- Bus status--

Live monitor (T=TX blue, R=RX green, newest at the top)

● TX   ● RX
Format: [T/R] Time(ms) ID DLC Data(hex) — click to expand details (0 records)
Waiting for CAN frames. On a live device, check the bus connection if no data appears.

External trigger

Trigger input (GPIO36, EL817 optocoupler)

Live status-- Total count0

System management

Account settings

OTA firmware update

System controls

System log